Fisher Price Riding Toy W1442 User Manual

W1442  
Please keep this instruction sheet for future reference, as it contains important information.  
Product features and decorations may vary from the photograph.  
Adult assembly is required. Tools required for assembly:  
Phillips Screwdriver, Hammer and Scrap Block of Wood (not included).  
Requires three "AA" batteries (included).  
Age: 2-6 years.  
Weight limit: 60 lbs (27 kg).  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Assembly  
Rear Wheel  
(Indented Side Up)  
CAUTION  
Cap Nut  
This product contains small parts  
in an unassembled state.  
Hubcap  
(Peg Side Down)  
Adult assembly is required.  
Cover  
Straight Axle  
Frame  
Hubcap  
Assembled  
Rear Wheel  
Rear Wheel  
(Indented Side Down)  
Scrap Block  
of Wood  
Cap Nut  
Assembly Tool  
3
Hubcap  
(Peg Side Up)  
Turn the frame on its side with the exposed end of the  
straight axle up.  
• Place the cap nut assembly tool under the assembled rear  
wheel and onto the cap nut.  
• Slide a rear wheel (indented side up) onto the end of the  
Straight Axle  
1
straight axle.  
• Slide a hubcap (peg side down) onto the straight axle.  
• Slide a hubcap (peg side up) onto the straight axle.  
• Slide a rear wheel (indented side down) onto the  
straight axle.  
• Place a cap nut on the end of the straight axle. Tap the  
cap nut with a hammer. Gently pull the rear wheel up  
to be sure the cap nut is securely attached to the  
straight axle.  
Frame  
• Insert one of the tabs on a cover into a slot in the hubcap.  
Push to snap the cover into place. Repeat this procedure to  
attach the other cover to the other hubcap.  
Pedal Hub  
Tab  
Pedal Axle  
Hole  
Hole  
Tab  
Slot  
Pedal Hub  
4
• Fit two pedal hubs onto the pedal axle tabs. Make sure the  
tabs fit into the slot in each pedal hub.  
Straight Axle  
2
BOTTOM VIEW  
Turn the frame upside down.  
• Insert the straight axle through the holes in the rear of  
the frame.  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
Assembly  
Pedal Hubs  
Pedal Axle  
Front Wheel  
Pedal  
Hole  
Pedal Axle  
5
• While holding the pedal hubs on the pedal axle, insert the  
pedal axle through the hole in the center of the front wheel.  
• Push the pedal hubs into the center of the front wheel until  
they are flush with the surface of the front wheel.  
Scrap Block of Wood  
7
Pedal Hub  
• Fit the pedal on the pedal axle. Tap the pedal with  
a hammer until it is secure.  
• Pull the pedal up to be sure it is secure. If you can remove  
it, you have not secured it properly. Tap it with the  
hammer again.  
Fork Arms  
Pedal Hub  
Fork Cover  
6
Groove  
Turn the front wheel assembly over.  
• Insert the remaining pedal hubs on top of and below the  
pedal axle and into the hole in the center of the front wheel.  
• Push the pedal hubs into the center of the front wheel until  
they are flush with the surface of the front wheel.  
Pedal Axle  
8
• Place the front wheel assembly between the fork arms.  
Make sure the pedal axle fits into the groove at the bottom  
of each fork arm.  
• Place a fork cover over the pedal axle on one fork arm.  
• Insert two #8 x 3/4" (1,9 cm) screws into the fork cover  
and tighten.  
• Repeat this procedure to attach the other fork cover to the  
other fork arm.  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
Assembly  
Slot  
Handlebar  
Headlight Cover  
Frame  
Neck  
Fork  
Post  
Fork Cover  
Rear of Trike  
9
11  
• Insert the fork post up through the hole in the neck of the  
frame. Make sure the fork is positioned so that the fork  
covers face the rear wheels.  
• Place the handlebar onto the fork post and push it down  
onto the frame. Make sure the handlebar is positioned so  
that the screw hole faces the rear wheels and aligns with  
the screw hole in the fork post.  
• Fit the tab on the headlight cover to the slot in the top of  
the handlebar.  
• Insert two #6 x 1/2" (1,3 cm) screws screws into the headlight  
cover. Tighten the screws.  
Seat Retainer  
Hint: You may need to rotate the handlebar to align the holes.  
Seat  
• Insert the #8 x 3" (7,6 cm) screw through the hole in the  
handlebar and into the fork post so that part of the screw  
(about 3/4"/1,9 cm) is still visible. Tighten the screw.  
Peg  
Cap  
Holes  
12  
• Position the seat upside down.  
• Fit the small pegs on the seat retainer into the holes in  
the seat.  
10  
• Insert and “snap” the cap into the hole in the frame.  
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
Label Decoration  
Attaching the Seat  
Hint: The seat can be attached to the frame in any of three  
positions, depending on the size of your child. Check  
your child’s fit on the trike by observing the seat to pedal  
distance, as it is being ridden. If the pedals seem too far  
away or too close for your child, move the seat up or down.  
(Place label 11  
on opposite side)  
(Place label 3  
on opposite side)  
10  
13  
2
1
Seat  
Tabs  
(Place label 5  
on opposite side)  
6
Seat  
Retainer  
Slots  
9
14  
(Place label 8  
(Place label 15 on  
opposite side of seat)  
12  
on opposite side)  
(Place remaining  
label 12’s on  
opposite side of  
front wheel)  
SIDE VIEW  
Middle Position  
Lower Position  
Upper Position  
• At an angle, insert the tabs on the seat into any of the top  
three sets of slots for the lower, middle or upper position.  
• Lower the seat so that the seat retainer inserts and snaps  
into the slots in the frame.  
• Pull up on the seat to be sure it is secure.  
4
7
DASH VIEW  
• Make sure the areas where the labels will be applied are  
clean and dry. Wipe your vehicle with a clean, soft, dry  
cloth to remove any dust or oils.  
• For best results, avoid applying a label more than once.  
• Apply the labels as shown in the illustration above.  
• After applying the label, rub the label firmly with a cloth to  
make sure the label is adhered to your vehicle.  
6
Download from Www.Somanuals.com. All Manuals Search And Download.  
Battery Replacement  
Battery Safety Information  
Note: For best performance, we recommend replacing the  
batteries that came with this trike with three, new "AA" (LR6)  
alkaline batteries.  
In exceptional circumstances, batteries may leak fluids that can  
cause a chemical burn injury or ruin your product. To avoid  
battery leakage:  
• Do not mix old and new batteries or batteries of different  
types: alkaline, standard (carbon-zinc) or rechargeable  
(nickel-cadmium).  
Headlight Cover  
• Insert batteries as indicated inside the battery compartment.  
• Remove batteries during long periods of non-use. Always  
remove exhausted batteries from the product. Dispose of  
batteries safely. Do not dispose of this product in a fire.  
The batteries inside may explode or leak.  
• Never short-circuit the battery terminals.  
• Use only batteries of the same or equivalent type,  
as recommended.  
• Do not charge non-rechargeable batteries.  
• Remove rechargeable batteries from the product  
before charging.  
• If removable, rechargeable batteries are used, they are  
only to be charged under adult supervision.  
FCC Statement  
1
(United States Only)  
This equipment has been tested and found to comply with  
the limits for a Class B digital device, pursuant to Part 15  
of the FCC Rules. These limits are designed to provide  
reasonable protection against harmful interference in a  
residential installation. This equipment generates, uses and  
can radiate radio frequency energy and, if not installed and  
used in accordance with the instructions, may cause harmful  
interference to radio communications. However, there is  
no guarantee that interference will not occur in a particular  
installation. If this equipment does cause harmful interference  
to radio or television reception, which can be determined by  
turning the equipment off and on, the user is encouraged to  
try to correct the interference by one or more of the  
following measures:  
• Loosen and remove both screws from the headlight cover.  
Remove the headlight cover.  
1,5V x 3  
AA(LR6)  
Battery Compartment  
• Reorient or relocate the receiving antenna.  
• Increase the separation between the equipment  
and receiver.  
• Consult the dealer or an experienced radio/TV technician  
for help.  
Note: Changes or modifications not expressly approved by  
the manufacturer responsible for compliance could void the  
user’s authority to operate the equipment.  
This device complies with Part 15 of the FCC Rules.  
Operation is subject to the following two conditions: (1)  
this device may not cause harmful interference and (2) this  
device must accept any interference received, including  
interference that may cause undesired operation.  
2
• Loosen the screw in the battery compartment door. Open  
the battery compartment door.  
• Insert three "AA" (LR6) alkaline batteries.  
• Close the battery compartment door and tighten the screw.  
• Replace the headlight cover. Replace the screws  
and tighten.  
• When sound or lights become faint or stop, it's time for an  
adult to replace the batteries. We recommend the use of  
alkaline batteries for longer battery life.  
• If this product begins to operate erratically, you may need  
to reset the electronics. Slide the power switch off and then  
back on.  
• Protect the environment by not disposing of this  
product with household waste (2002/96/EC). Check  
your local authority for recycling advice and  
facilities (Europe only).  
7
Download from Www.Somanuals.com. All Manuals Search And Download.  
Removing the Seat  
Consumer Information  
Seat  
CONSUMER ASSIS
T
A
NCE  
1-800-432-5437 (US & Canada)  
1300 135 312 (Australia)  
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.  
Hearing-impaired consumers: 1-800-382-7470.  
Seat Retainer Tab  
Outside the United States:  
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,  
Great Britain: Mattel UK Ltd, Vanwall Business Park,  
Maidenhead SL6 4UB. Helpline: 01628 500303.  
Mattel Europa, B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.  
Australia: Mattel Australia Pty. Ltd., 658 Church Street,  
Locked Bag #870, Richmond, Victoria 3121 Australia.  
Frame  
New Zealand: 16-18 William Pickering Drive,  
Albany 1331, Auckland.  
Seat Retainer Tab  
IMPORTANT! It is good practice to start training children very  
young regarding the importance of helmet use. When children  
are older and riding bicycles and faster vehicles, it is important  
that they use a helmet each and every time they ride. For  
this reason, even while riding a tricycle, it is a good idea to  
familiarize your child with helmet use, so that it becomes a habit  
for life. Choose a helmet that complies with requirements of the  
applicable certifying agency for bicycle helmets.  
Turn the frame on its side.  
• Squeeze the seat retainer tabs toward one another and lift  
the seat from the frame.  
Care  
Let's Go!  
• Check the plastic parts regularly and if broken or cracked,  
dispose of them properly.  
• Check all fasteners regularly to be sure they are tight.  
If the fasteners are not tight, tighten them as necessary.  
To clean, use a mild soap and water solution and a clean  
cloth. Rinse clean with water to remove soap residue.  
Sounds  
Music  
Ignition  
Sounds  
ICES-003  
• This Class B digital apparatus complies with Canadian  
ICES-003.  
• Operation is subject to the following two conditions: (1)  
this device may not cause harmful interference and (2) this  
device must accept any interference received, including  
interference that may cause undesired operation.  
Sounds  
Power Switch  
NMB-003  
• Cet appareil numérique de la classe B est conforme à la  
norme NMB-003 du Canada.  
Turn Signal Horn  
Turn Signal  
Lutilisation de ce dispositif est autorisée seulement  
aux conditions suivantes : (1) il ne doit pas produire de  
brouillage et (2) l’utilisateur du dispositif doit être prêt  
à accepter tout brouillage radioélectrique reçu, même  
si ce brouillage est susceptible de compromettre le  
fonctionnement du dispositif.  
• Slide the power switch ON.  
Turn the ignition, “VRROOOM!”  
• Press the left or right turn signals for flashing blinkers.  
• Press any of the buttons for fun sounds!  
8
Download from Www.Somanuals.com. All Manuals Search And Download.  

Cornelius Beverage Dispenser Ice Cooled Dispensers User Manual
Cornelius Beverage Dispenser Ice Drink Dispenser with Flavor Shot User Manual
Craftsman Snow Blower C950 52943 0 User Manual
Cub Cadet Snow Blower 826 4x4 User Manual
Cuisinart Convection Oven Delux Convection Toaster Oven Broiler User Manual
Euro Pro Food Processor KP81E User Manual
EverFocus Home Security System ED705 User Manual
Fender Musical Toy Instrument PM 1 Deluxe User Manual
Freecom Technologies Computer Drive Desktop Hard Drives User Manual
Fujitsu Flat Panel Television P42VCA10 P42HCA10 P50XCA10 P42VCA20 P42VCA11 P42HCA11 P50XCA11 P42VCA21 P42VCA12 P42HCA12 P50XCA12 P42VCA22 User Manual