| Sirius Satellite Radio Stratus 6 SDSV6QSG 092109a User Manual | 
| Pick a Spot for Your Radio (continued)   2 Install the Magnetic Mount Antenna   5 PowerConnect   1 Pick a Spot for Your Radio   3 Connect the Audio to Your Vehicle’s Stereo   PowerConnect (continued)   Installing the Vent Mount:   If you have connected the audio in step 3 using the Aux In Cable or Cassette Adapter, continue with step 6.   Decide How to Connect   You will listen to the Stratus 6 through your vehicle’s stereo system or FM radio. First, the Stratus 6 must be receiving the   SIRIUS signal. Ensure your vehicle is outside with the antenna having a clear view of the sky. Your audio connection options are:   Mount the Magnetic Mount Antenna   Choose the best location for the antenna considering your vehicle type. Refer to the antenna   placement tips and cautions in the User Guide beginning on page 23.   Install the Dash or Vent Mount   Extended Vent Clamps   1 Locate a suitable vent in your vehicle which is strong enough to   hold the Stratus 6 and the PowerConnect Vehicle Dock. (Options   4 or 5.)   You can use either the Dash Mount or the Vent Mount for your Stratus 6, depending upon your vehicle and   the location where you want to place your radio.   4 You May Need to Try Other FM Channels on Your List   Tune the Stratus 6 and Vehicle FM Radio to the Same FM Channel   • Best: Use the Aux In Cable if your vehicle’s stereo system has   • Sedan or Coupe: We recommend mounting the antenna above either the front windshield or   the back window.   • Pickup Truck: We recommend mounting the antenna above the front windshield.   • Convertible: We recommend mounting the antenna at the leading edge of the trunk.   • SUV: We recommend mounting the antenna at the rear of the roof.   If the chosen FM channel doesn’t work well for you, work down the list of FM channels until you find   one that allows you to hear SIRIUS clearly. Each time, you will need to tune your vehicle’s FM radio   and the Stratus 6 to the same FM channel.   Audio Quality   GOOD BETTER   BEST   CAUTION! Make sure your radio isn’t in a place where it could interfere with driver visibility or safe deployment   of the airbags.   1 Find an Available FM Channel in Your Area   an auxiliary input connection. Plug one end of the cable into the   green AUDIO connector on the PowerConnect Vehicle Dock and   the other end into the vehicle stereo system’s auxiliary input jack.   Set the stereo system to play from the auxiliary input source.   2 If the vent louvers are recessed, you’ll have to use the   extended vent clamps. The Vent Mount is assembled with the   short vent clamps, so you will have to remove the short clamps   and install the extended clamps as shown below.   Short Vent   Clamps   FM Direct Adapter (FMDA)   Aux In Cable   An available FM channel is one that’s not being used by an FM radio station in your area. When you   tune your FM radio to an available channel, you should only hear static or silence – not talk or music.   We recommend one of the following methods to find an available FM channel:   Installing the Dash Mount:   TIP! You may find an FM channel with static or silence that does not work with the Stratus 6. It is possible that   some type of inaudible interference is present that prevents reception of the Stratus 6 broadcast. Your only   options are to use another FM channel or a different audio connection method.   Cassette Adapter   PowerConnect   CAUTION: The adhesive used on the Dash Mount may be difficult to   remove. Do not install this mount on leather surfaces (contact your vehicle   dealer if you are unsure about your dash surface), and make sure the air   temperature is at least 60ûF (15ûC) during installation. If it’s not at least   CAUTION! STOP and read the more specific instructions in the User Guide for all   types of vehicles — or get someone who knows vehicles to help — if you don’t   understand what to do. You might accidentally do damage to your vehicle.   Remove End Cap   enter your zip code. The Channel Finder will suggest a list of available FM channels in your area.   For convenience, write down or print out the list.   Slide Short Vent Clamps Out   Dash   Mount   sel   jump   Vent Mount   60ûF, turn on the heater in your vehicle to bring the temperature up to 60ûF.   Attach the Rubber Tail to the antenna and press   the antenna cable into the Rubber Tail. Use the   Rubber Tail to position the antenna the correct   distance from the edge of the roof or trunk lid.   Magnetic Mount Antenna   (Upside-Down)   OR   AUDIO   ANT   Option 4   1 Locate a flat surface for the Dash Mount. (Options 1, 2, or 3.)   b. Manually tune through your local FM channels on your vehicle’s FM radio. Locate and create a list of   channels that aren’t being used by any FM radio station. Write down the list. Once you have created   your list of available FM channels, you will need to find the one that provides the best match for the   Stratus 6.   • Better: Use a Cassette Adapter if your vehicle has a built-in cassette   Make sure there is   Option 1   I II   player. Cassette Adapters are sold separately. Plug the Cassette Adapter   into the green AUDIO connector on the PowerConnect Vehicle Dock. Insert   the Cassette Adapter into the vehicle’s cassette deck. Set the stereo   system to play from the cassette source.   ample room for the   dock and radio when   installed.   AUDIO   ANT   Clean the surface of the selected mounting   location using the alcohol preparation pad and   let it dry thoroughly. Peel the protective material   from the adhesive strips and press the Rubber   Tail firmly into place on the vehicle for 30   seconds. At room temperature (68° F), maximum   adhesion usually occurs within 72 hours. During   this period, avoid car washes and other contact   with the antenna and the Rubber Tail.   Protective   Material   Slide Extended Vent Clamps In   Replace End Cap   TIP! You’ll need to use the ‘Manual’ tune function on your vehicle’s FM radio to tune through every FM channel   one-by-one. Turn on your vehicle’s FM radio. Start at 88.1 and use the ‘Manual’ tune function on your vehicle’s FM radio   to tune through each FM channel one-by-one (88.1 followed by 88.3 etc.) to locate channels that aren’t being used by   a local FM radio station. Write down each FM channel that has only static or silence on it, until you reach 107.9.   Strain   Relief   jump   2 Set the orientation   of the mount before   adhering it. Loosen   the knob and adjust   the adhesive foot for the location you   selected:   • Good: Use the PowerConnect feature in the Stratus 6. PowerConnect   6 Activate   sel   Rubber   Antenna   Tail   plays the audio through your vehicle’s FM radio. When you have finished step 4 (below), you’ll first need to   find an available FM channel in your area, and then you need to ensure that the Stratus 6 and your vehicle’s   FM radio are tuned to the same available FM channel. (Step 5)   jump   2 Tune your Vehicle’s FM Radio   Antenna Cable   Activate Your Service   Before you can enjoy Commercial-Free Music, Plus Sports, News, Talk & Entertainment, you need to activate   your Stratus 6.   • Best: Use an FM Direct Adapter (FMDA) if none of the above three audio connection options works in your   vehicle. The FMDA needs to be installed by a professional installer and directly connects the Stratus 6 to your   vehicle’s FM radio.   a Pick the first FM channel on your list.   • Option 1 & Option 3 should be oriented as I.   Option 5   Feed the antenna wire under the rubber molding around the front or rear   windshield, and into the seal around the trunk or door. For a convertible, the cable   can be routed directly into the trunk.   b Turn on your vehicle’s FM radio (if you have not already done so) and tune it to this FM channel.   • Option 2 should be oriented as II.   3 Attach the Vent Mount to the PowerConnect Vehicle Dock   Option 2   TIP! Refer to your vehicle’s owners manual to find the location of the auxiliary input jack, or consult the vehicle   dealer. To learn more about purchasing a Cassette Adapter or FMDA, check with the retailer where you bought your   Stratus 6 or go to sirius.com/accessories.   using the provided screws.   3 4 5 Clean the surface with the   alcohol preparation pad, and let   it dry thoroughly.   1 Make sure your Stratus 6 is properly installed, turned on, and receiving the SIRIUS signal so that   you can hear the audio on channel 184.   TIP! Use a tool like a blunt plastic putty knife, a credit card, a plastic knife, or a   similar blunt tool to help hide wires along the windshield trim.   sel   sel   jump   menu   96.3   2 Make a note of your SIRIUS Radio ID. You can find it:   jump   sel   Attach the Dash Mount to the   PowerConnect Vehicle Dock   using the provided screws.   jump   TIP! If the signal reception   Hide the Magnetic Mount Antenna Cable Inside the Vehicle   The best place to hide your antenna cable depends on your type of vehicle.   • On channel 0 (zero)   is low, check to see if the   antenna’s view of the sky is   blocked by a tree, a   building, a bridge, or by   anything on the vehicle   roof such as a roof rack or   luggage container, etc.   Adjust until you are   MATCH FM CHANNELS   4 Finish the Installation and Power On   • On a label on the bottom of the gift box   • On the label on the back of your Stratus 6   When the antenna is mounted at the rear of the vehicle, it’s usually easiest to run   the cable from the rear to the front toward the radio by routing the cable along   the interior trim where it meets the carpet, gently pushing it behind the edges of   the trim. Bring the cable out from the trim and route it under the carpet toward   the dashboard.   3 Set Your Stratus 6 to Transmit on the Same FM Channel   Peel off the adhesive liner.   Position, press, and hold the Dash   Mount in place for 30 seconds.   a Press and hold menu until the menu options are displayed.   Connect the PowerConnect Power Adapter   sel   jump   3 4 Activate your service:   4 5 Push the Vent Mount onto the vehicle vent as shown (1) until   hooked on the rear of the vent louver (2).   b Press   c If FM Channels is not highlighted, press   d Press to scroll to and highlight the storage location FM2. Press the Select button.   e Tune to the FM channel you found in step 1. Press and to tune in   to scroll to and highlight FM Settings and press the Select button.   Activate”   Insert the PowerConnect Power Adapter into your vehicle’s cigarette lighter or power adapter   socket. Then plug it into the red PWR connector on the left side of the dock.   IMPORTANT! Allow the Dash Mount   adhesive to cure (dry) for a minimum of   2-4 hours before using the mount. The   best adhesion occurs after 24 hours.   to highlight FM Channels. Press the Select button.   receiving a good signal.   To check the signal, press   Option 3   When the antenna is mounted at the front of the vehicle, bring the cable into the   rubber weather stripping around the door to the bottom of the door opening.   Bring the cable out of the weather stripping and route it   Rest the foot against the bottom of the vent (2). If necessary,   adjust the tilt of the Vent Mount by repositioning the foot to a   different tilt adjustment hole (3).   OR   PWR   FM   and hold menu, press   scroll to and highlight   Signal. Press the Select   button to display the   Signal screen.   to   • By phone: Call 1-888-539-SIRIUS (1-888-539-7474)   Place the Radio in the Dock   Insert your Stratus 6 into the dock,   under the carpet toward the dashboard.   sel   jump   6 The dock mounting plate can be tilted in different directions.   Adjust as necessary for your particular vehicle. When the   orientation is correct, tighten the knob.   FM Channels   96.3 FM   steps of .2, i.e., 99.3 to 99.5. Press and to tune in steps of 1, i.e.,   99.3 to 100.3. Press the Select button to select the FM channel.   sel   When your service is activated, your Stratus 6 will display an   alert message. To continue, press any button. Thereafter, if you   menu   1 2 3 Coil any excess cable in a hidden location, such as under   the carpet, keeping it away from any vehicle pedals or   controls. Secure the excess cable with wire ties.   aligning the radio against the rear of   jump   press   or , you can scroll and tune other channels. Activation   Dash   Dash   Vent   Dash   the dock so that the rails on the dock   fit into the mounting slots in the back   of the radio.   f The FM channel you selected will be confirmed on the display screen.   The Stratus 6 will tune to the FM channel.   Signal   SAT -   TER -   sel   jump   AUDIO   ANT   usually takes less than 5 minutes, but sometimes may take   longer. We recommend that your radio remain on until activated.   HOOKED   PUSH   Knob   Adhesive Foot   Dock Mounting   Plate   + + Plug the antenna into the silver ANT connection on the   right side of the dock.   FM Channels   >FM2 96.3   FM3 Empty   g You should hear SIRIUS through your vehicle’s radio when Stratus 6 is   tuned to channel 184. If you are satisfied with the sound quality, you’re   done.   AUDIO   ANT   Vent   AUDIO   ANT   Vent   TILT   TIP! Avoid damaging or compromising the window,   door, and trunk seals.   Press the Power button to turn it On.   ADJUSTMENT   HOLES   FOOT   Louver   TIP! For more help, refer to the detailed antenna cable   routing instructions for your type of vehicle, in the User Guide beginning on page 26.   |