| Lighting Systems A-9   1BHFꢃꢂꢃPGꢃꢆꢃ   "MFSPOÜꢃ4FSJFTꢃꢆꢃꢌꢃꢂꢌ-JHIUꢃ5ꢈꢃ1FSꢃꢍhꢃ ꢂꢆꢂꢎꢋꢆDNꢊꢃ4FDUJPO   3 2 1 5 3-5/16”   (8.41cm)   6 2-3/16”   (5.56cm)   NOT TO SCALE   8-1/16” (20.48cm)   Module Ordering Information   Family   Series   Track   Length   Shielding   Lamps   Finish   Options   A 2 A A E1 = Emergency Pack, 120v   E2 = Emergency Pack, 277v   D1 = Dimming 120v   D2 = Dimming 277v   X5 = 5 Through Wires   A = Solid   28 = 28w   54 = 54w   4 = 4-Foot   8 = 8-Foot   12 = 12-Foot   WH = White   AL = Aluminum   A = Track   B = No Track   B = Perf   C = Pierce   D = Lens   Complete ordering instructions below.   Features   Electrical   1. Housing: Extruded aluminum housing in lengths of 4’ (121.92cm), 8’ (243.84cm)   and 12’ (365.76cm). There are no exposed fasteners. The end caps are die-cast   aluminum sculpted and finished to match the housing.   Ballast is <10% THD, 1.0 ballast factor, program start. Color-coded quick   connectors allow ease of connection for joiner modules. For special circuiting   consult factory. Factory installed ballast disconnect allows the ballast to be   disconnected from and reconnected to incoming power under load without turning   the entire circtuit off.   2. Reflector: Die-formed high purity anodized specular aluminum.   3. Lamping: One T5 28W or 54W lamp per four-foot nominal length. Provided   by others.   4. Alignment Mechanism: The housing and the end cap each have a draw tight   mechanism that creates a hairline joint along and at the ends of the run. To   operate the mechanism, the installer tightens two screws.   5. Track Option: The housing has the capability of having single circuit Lytespan   track fixtures for accent lighting. The track is an integral component of the   housing. The fixture housing comes with a cover to conceal any portion of the   track that doesn’t have a track fixture installed. The cover can be cut to length   in the field. There is an optional cover (ATC) that creates a nearly seamless   transition from the fluorescent fixture to the track fixture.   Dimming: 120/277 VAC 1% dimming level, 4 or 5 wire feed required.   Emergency Battery Pack: 28 watt: 520 lumens @ 90 minutes, 54 watt: 700   lumens @ 90 minutes.   There are two types of power feed end sets for the track option. One has a stem   containing five solid wires and the other end set has one 5 wire and one 3 wire   stem. Single power feed end sets allow for 16 amps of track fixtures per run while   dual power feed end sets allow 32 amps per run.   ® Ordering Instructions   Individual Fixtures:   1. Order number of MODULES required.   2. Order one POWER FEED END SET per MODULE.   6. Shielding: Die-formed 20 gauge steel finished to match housing.   Labels   Continuous Rows:   1. Determine run length.   UL, cUL and I.B.E.W.   2. Order the appropriate number of MODULES for the complete run.   3. Order one POWER FEED END SET per run.   4. Order one INTERMEDIATE SUSPENSION per MODULE minus one per run.   5. For runs that exceed amperage limits, order the appropriate number of   INTERMEDIATE POWER FEEDS.   Finish   Powder coated baked white or silver enamel.   Custom colors available, consult factory.   Mountings   All mounting is on 48” (121.92cm), 96” (243.84cm) and 144” (365.76cm) centers.   Job Information   Type:   Cable Suspension (not shown) 4-1/2" (11.43cm) diameter flat canopy finished   white enamel, 1/16" (0.16cm) diameter stainless steel aircraft cable adjustable up   to 36" (91.44cm) and adjustable cable gripper. Cable mounting at the ends of a run   is not available when track is being used. Installing stems at the ends of the run   will prevent the fixture from hanging off center caused by the weight of the track   fixture. Cable suspension can be used in the center of runs that have track   installed. Consult factory for other options.   Job Name:   Cat. No.:   Lamp(s):   Notes:   Stem Mounting (not shown) - 4-1/2" (11.43cm) diameter flat canopy, 1/4"   (0.64cm) IP (1/2” (1.27cm) OD) stem. The stem can accommodate up to 2-12 gauge   and 3-18 gauge solid wires. All components have a white finish.   ꢀꢁꢂꢃ"JSQPSUꢃ3PBEꢄꢃ'BMMꢃ3JWFSꢄꢃ."ꢃꢅꢆꢇꢆꢅꢃtꢃ ꢈꢅꢉꢊꢃꢀꢇꢋꢌꢉꢂꢁꢂꢃtꢃ'BYꢃ ꢈꢅꢉꢊꢃꢀꢇꢍꢌꢍꢇꢂꢅ   We reserve the right to change details of design, materials and finish.   XXXꢎMJHIUPMJFSꢎDPNꢃ½ꢃꢆꢅꢅꢉꢃ1IJMJQTꢃ(SPVQꢃt $ꢅꢋꢅꢉ   Download from Www.Somanuals.com. All Manuals Search And Download.   |