Model: 8250-0
PACKAGE CONTENTS
Item i
Item j
Item k
UniDIN™
DIN Rail Mounting Bracket Kit for
FlexPoint™ and iConverter® User Manual
OVERVIEW
The Omnitron Universal DIN Rail Mounting Bracket model 8250-0 is designed
to provide DIN Rail mounting capabilities for the FlexPoint converter, FlexPoint
converter with DCAdapter, iConverter® Stand-Alone and iConverter 1-module
chassis. This kit contains all the necessary components to provide DIN Rail
mounting for several different mounting orientations.
(2) DIN Rail Bracket
Halves (Pre-assembled)
(2) DIN Rail Bracket Hex
Nuts (Pre-assembled)
(2) DIN Rail Clips
(Pre-assembled)
Item m
Item n
User Manual
(2) DIN Rail Clip Screws
(Pre-assembled)
(4) Bracket Mounting
Screws (In separate bag)
ASSEMBLY AND MOUNTING INSTRUCTIONS
STEP 1. Adjusting Bracket Width
If bracket width adjustment is necessary, loosen the hex nuts ( j ) on the DIN
Rail bracket ( i ) and align the DIN Rail bracket width to match the width of the
media converter. After adjusting the DIN Rail bracket to the desired width,
tighten the hex nuts ( j ) to lock the DIN Rail bracket width.
Figure 1. Pre-assembled Configuration - Mounting Orientation [B]
MOUNTING ORIENTATIONS
This diagram illustrates a converter in four different DIN-Rail mounting orientations.
As shipped from the factory, the UniDIN is ready to be used in configuration [B].
Rear Cover Screw
i
Front Cover
Screw
j
[A]
i
[B]
Converter
[C]
[D]
Figure 2. Mounting Orientations
Figure 3. Adjusting Bracket Width to Match Width of Media Converter
Download from Www.Somanuals.com. All Manuals Search And Download.
|