Hollywood Sport Rider HR1000 User Manual

Pour instructions en Français, continuer aux pages 6 et 7.  
HOLLYWOOD RACKS  
Sport Rider Instruction Manual  
Model HR1000 – 2 Bike Hitch Rack with ratcheting hooks  
Not to be used on any trailer, fifth  
wheel or vehicle being towed by  
another vehicle  
Weight Limit 45lbs/20 kg per bike  
2 bike maximum capacity  
Optional locking kits available  
ID#  
Description  
Qty  
A
B
C
D
E
F
G
H
I
J
K
L
M
N
P
MAIN RACK ASSY  
1
1
1
1
2
2
2
1
4
4
1
2
1
1
SHORT FRAME HOOK  
LONG FRAME HOOK  
RECEIVER TUBE & SPACER  
LEFT SIDE WHEEL TRAY  
RIGHT SIDE WHEEL TRAY  
REC. TUBE STOP BOLTS  
LOWER BRACKET  
8MM BOLTS  
FLAT WASHERS  
5MM HEX KEY  
LOCK WASHERS  
½-13 THREADED HITCH PIN  
HITCH PIN CLIP  
WHEEL TUBE STOP SCREWS 2  
A
B
C
O
F
D
E
1
Step 6: Install frame hooks:  
Step 6A: Installing into a 1 ꢀ” trailer  
Slide long frame hook down  
vertical post facing vehicle.  
Then slide short frame hook  
onto post, facing away from  
vehicle. You should hear be able  
to hear the spring loaded lever  
engaging the teeth on the post  
as shown in fig. 8.  
Note: The receiver tube comes  
ready for installation into a 2”  
hitch. If you have a 1 ꢀ” hitch,  
use the provided hex wrench to  
remove the plastic spacer as  
shown in Fig. 9.  
Fig. 9  
Place lock washer and flat washer  
onto hitch pin bolt as indicated.  
Insert the receiver tube into the  
hitch. Align the holes, insert the  
hitch pin bolt and tighten securely  
using a ꢁ” wrench.  
Fig. 10  
Fig. 11  
Fig. 8  
Important! When inserting the hitch pin  
bolt, the bolt should pass through the  
receiver tube first then through the  
plastic spacer.  
Step 6 B: Installing into a 2” trailer hitch  
Place lock washer and flat washer onto hitch pin  
bolt as indicated. Insert the receiver tube into the  
hitch. Align the holes, insert the hitch pin bolt  
and tighten securely using a ꢁ” wrench.  
Fig. 12  
Fig. 13  
Fig. 14  
Install Hitch pin clip  
after tightening bolt  
Fig. 15  
3