HP Hewlett Packard Switch 2610 Series User Manual

Read Me First  
for the ProCurve Switch 2610 Series  
Contents  
IMPORTANT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 1  
Note for the 2610-PWR Switches . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 1  
About Your ProCurve Switch 2610 Series Manual Set. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 1  
View or Download the Software Manual Set . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 2  
Your Free Introduction to Proactive Networking! . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 2  
Software Updates Are Free! . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 2  
ProCurve Networking Support Services . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 3  
Mini-GBIC Operation Notes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 4  
IMPORTANT  
The PoE Planning and Implementation Guide is not being shipped with this switch. To view or print a copy see:  
Note for the 2610-PWR Switches  
The 2610-PWR switches support some pre-standard PoE devices. However, the use of a cross-over cable may  
be required. For a current list, see the FAQ page for the 2610-PWR switches on the ProCurve Web site by going  
to www.procurve.com and clicking on:  
Customer Care > Support > FAQs > ProCurve Switch 2610-24-PWR, 2610-48-PWR, and 2610-24/12PWR  
About Your ProCurve Switch 2610 Series Manual Set  
The switch manual set includes the following:  
Document  
Available on the HP  
ProCurve Web site  
Shipped With  
the Switch  
1
Read Me First (this document)  
Yes  
Yes  
Yes  
Yes  
Yes  
Yes  
Yes  
Yes  
Yes  
No  
No  
No  
No  
No  
1
Installation and Getting Started Guide  
1
1
PoE Planning and Implementation Guide  
1
Advanced Traffic Management and Guide  
1
Access Security Guide  
1
Release Notes (for software updates)  
1
The latest edition is always available in PDF format and downloadable as described in “View or Download the Software Manual Set” on  
page 2.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
     
HP ProCurve Networking Support Services  
HP offers a wide variety of onsite and offsite support services for HP ProCurve networking products. For a list  
of available services, visit www.procurve.com and click on Customer Care.  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
 
Mini-GBIC Operation Notes  
Revision “B” and “C” mini-GBICs only. This product requires ProCurve revision “B” or later mini-GBICs  
(product number ends with the letter “B” or “C”, for example J4858B, J4859C). These switches do not support  
revision “A” mini-GBICs.  
Use only genuine ProCurve mini-GBICs. Non-ProCurve mini-GBICs are not supported. Use of genuine  
productsensuresthatyournetworkmaintainsoptimalperformanceandreliability. Shouldyourequireadditional  
ProCurve mini-GBICs, please contact a ProCurve sales representative or an authorized reseller.  
Hot Swapping mini-GBICs. The mini-GBICs that you can install in your ProCurve Switch can be “hot  
swapped”—removed and installed after the switch is receiving power. Youshould disconnect the network cables  
from the mini-GBICs before hot swapping them.  
When you replace a mini-GBIC with another mini-GBIC of a different type and then execute the write memory  
command in the switch console, the switch configures the port on the new mini-GBIC with the default mode  
(speed and duplex) settings used for new mini-GBIC type. The default mode for the mini-GBICs is Auto. The  
switch retains other port-specific configuration settings, such as trunking, Spanning Tree Protocol (STP), and  
VLAN values that were configured for the previous mini-GBIC.  
Connecting the mini-GBICs to Devices with Fixed Configurations. For some older network devices,  
including some older ProCurve devices, the default for Gigabit ports is a fixed configuration, for example 1000  
Mbps/Full Duplex, or is otherwise different from these default configurations for the mini-GBICs, which is Auto.  
As a result, those devices may not connect properly to your mini-GBIC port; you will not get a link. Because of  
these default configuration and full-duplex considerations, for best operation, you should make sure that the  
devices connected to the mini-GBIC ports are also configured to Auto. At a minimum, make sure the  
configurations match.  
Part Number: 5992-3122  
June 2008  
Printed in China  
© Copyright 2005-2008 Hewlett-Packard  
Development Company, L.P.  
The information contained herein  
is subject to change without notice.  
*5992-3122*  
Download from Www.Somanuals.com. All Manuals Search And Download.  
 

Graco Car Seat 8A12BKR User Manual
Graco High Chair ISPH023AA 12 06 User Manual
Grindmaster Coffeemaker 67710E User Manual
Grizzly Saw G9744Z2 User Manual
Grizzly Vacuum Cleaner G0631 User Manual
Hand Held Products Laptop Dolphin 7400 User Manual
Heat Glo LifeStyle Indoor Fireplace 6000TRI IPI User Manual
Heat Glo LifeStyle Indoor Fireplace ST 42TVFL IPI User Manual
HP Hewlett Packard Digital Camera 2425 User Manual
Ide Line Microwave Oven 751 079 User Manual