Grizzly Automobile Parts h6236 User Manual

Low Profile  
Transmission Jack  
MODEL H6236  
The Model H6236 Transmission Jack (Figure 1)  
features a 1000 pound weight capacity, adjust-  
able platform for precision placement and steel  
swivel casters for high maneuverability.  
Inventory (Figure 1)  
A
A. Jack Base................................................... 1  
B. Handle........................................................ 1  
C. Adjustable Brackets.................................... 4  
D. Hardware Bag ............................................ 1  
—Hex Bolts M10-1.25 x 16......................... 8  
—Flat Washers 10mm................................ 8  
—Chain Tensioning Hook .......................... 1  
—Flat Washers 6mm ................................. 2  
—Wing Nuts M6-1...................................... 2  
—Chain 4mm x 39 1/2".............................. 1  
C
B
D
Figure 1. Model H6236.  
Assembly & Operation  
1. Attach the adjustable brackets to the platform  
with M10-1.25 bolts and 10mm flat washers.  
2. Thread a M6-1 wing nut, wings up, followed  
by a 6mm flat washer to the chain tensioning  
hook.  
This jack is designed for the assistance of  
transmission removal only. Failure to follow  
these warnings will result in serious personal  
injury or death:  
3. Locate the tab with the center hole on the  
platform.  
1. DO NOT overload this jack beyond its  
rated capacity. Overloading can cause the  
the jack to collapse and drop the load.  
2. ALWAYS support the load with an appro-  
priately rated support stand before working  
under the vehicle.  
3. DO NOT attempt to move the vehicle while  
the jack is under it.  
4. Use only on hard level surfaces like con-  
crete or asphalt. Other surfaces are poten-  
tially unstable.  
4. Slide the threads of the chain tensioning  
hook through the center hole and follow with  
6mm flat washer and M6-1 wing nut.  
5. When the platform has been raised to meet  
the workpiece, slide one end of the chain over  
the hook. Wrap the chain over the workpiece  
and fit the other end of the chain into the slot-  
ted tab on the opposite side of the platform.  
6. Use the wing nuts on the chain tension hook  
to tension the chain. This will provide addi-  
tional stability to the workpiece.  
5. Center the load on the jack to maintain  
proper balance.  
7. Turn the pump knob clockwise to close the  
valve.  
8. Insert the handle into the pump socket and  
pump the handle to raise the platform.  
9. Slowly turn the pump knob counterclockwise  
to lower the platform.  
If you need additional help with this procedure,  
call our service department at: (570) 546-9663.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Graco Inc Heat Pump 3A1450D User Manual
Graco Inc Paint Sprayer 223390 User Manual
Graco Marine Instruments 246008 User Manual
Harbor Freight Tools Lathe 33684 User Manual
Honeywell Digital Camera VCC 600N P User Manual
Hotpoint Range RGB524PPAWH User Manual
HP Hewlett Packard Computer Drive DAT 72 User Manual
HP Hewlett Packard Laptop Docking Station XB4000 User Manual
HP Hewlett Packard Switch A7340 96002 User Manual
Humminbird Switch 531870 1_A User Manual