DCVH680GJ
GE® 7.0 Cu. Ft. Super Capacity Frontload Gas Dryer
Dimensions and Installation Information (in inches)
27
31-1/8
Gas Dryer Rating
1-5/8
60Hz, 6A
120V
Exhaust Options: 3-way via rear, left, and bottom.
Circuit Requirements: An individual, properly grounded
branch circuit, protected by a 15-20 amp circuit breaker
or a time-delay fuse, is required.
Note: Dryer wall outlet must be located within 36”
of service cord entry and accessible when dryer is
mounted in position.
41-1/2
Installation Information: For complete information, see
installation instructions packed with your dryer.
3-3/4
5-1/2
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
ge.com or call GE Answer Center® service,
800.626.2000.
Specification Revised 8/09
360453
Download from Www.Somanuals.com. All Manuals Search And Download.
DCVH680GJ
GE® 7.0 Cu. Ft. Super Capacity Frontload Gas Dryer
Dryer Exhausting Information – Metal Duct Only
For complete information, see installation instructions packed with your dryer.
Best performance
Ducting Materials: For best performance, this dryer should be vented with 4” diameter
all rigid metal exhaust duct. If rigid metal duct cannot be used, then UL-listed flexible
metal (semi-rigid) ducting can be used (Kit WX08X10077). In special installations, it may
be necessary to connect the dryer to the house vent using a flexible metal (foil-type) duct.
A UL-listed flexible metal (foil-type) duct may be used ONLY in installations where rigid
metal or flexible metal (semi-rigid) ducting cannot be used AND where a 4” diameter can
be maintained throughout the entire length of the transition duct. Please see installation
instruction packed with your dryer for complete instructions when using flexible metal (foil
type) ducting.
Maximum length of 4"
A
A
dia. rigid metal duct
Exhaust hood type
4
B
Number
of
A
4"
B
90°
Domestic
dryer models
2-1/2"
opening
2-1/2
turns
opening
0
1
2
3
90 ft.
60 ft.
45 ft.
35 ft.
60 ft.
45 ft.
35 ft.
25 ft.
Exhaust Length Calculation:
7.0, 6.0 and 5.8 cu. ft.
capacity models
all gas dryers
1. Determine the number of 90° turns needed for your installation. If you exhaust to the
side or bottom of dryer, add one turn.
2. The maximum length of 4’ rigid (aluminum or galvanized) duct which can be tolerated is
shown in the table.
A turn of 45° or less may be ignored. Two 45° turns within the duct length should be
treated as a 90° elbow.
A turn over 45° should be treated as a 90° elbow.
Dryers must be exhausted to the outside.
Caution: For personal safety do not terminate exhaust into a chimney, under any enclosed
house floor (crawl space), or into an attic, since the accumulated lint could create a fire
hazard or moisture could cause damage. Never terminate the exhaust into a common duct
or plenum with a kitchen exhaust, since the combination of lint and grease could create a
fire hazard.
Exhaust ducts should be terminated in a dampered wall cap to prevent back drafts, bird
nesting, etc. The wall cap must also be located at least 12" above the ground or any other
obstruction with the opening pointed down.
For more information on venting kits and accessories, please call 1-800-GE-CARES.
Specification Revised 8/09
360453
Download from Www.Somanuals.com. All Manuals Search And Download.
DCVH680GJ
GE® 7.0 Cu. Ft. Super Capacity Frontload Gas Dryer
Features and Benefits
• 7.0 Cu. Ft. Super Capacity - Handles large-size items and family-size loads
• Sensor Dry Plus™ - Continually monitors moisture levels to help clothes look
better longer
• Rotary Electronic Controls with Cycle Countdown Display and LED Indicators -
Simplify the cycle selection and provide accurate cycle times
• Interior Dryer Light - Lets you see everything inside for easy loading and unloading
• Deluxe Quiet - Provides near-silent performance with a quiet-engineered motor
and components, plus an extra layer of insulation
• Adjustable End-Of-Cycle Signal - Alerts you when cycle is done, saving time
between loads
• Multiple Dry Cycles - Deliver optimal drying results
• Anti-Bacteria Option - Certified by the NSF® to reduce up to 99% of certain types
of bacteria
• 5 Heat Selections - Offer enhanced drying performance and fabric care
• DuraDrum™ - Provides long-lasting dependability and durability
• Damp Dry Signal - Reminds you when to remove select items for hang-drying
• Delay Start - Lets you do the laundry on your terms
• Model DCVH680GJBB – Black on black
• Model DCVH680GJMR – Metallic red
• Model DCVH680GJMS – Metallic silver
• Model DCVH680GJWW – White on white
• Model DCVH680GJMV – Vermillion Red
Specification Revised 8/09
360453
Download from Www.Somanuals.com. All Manuals Search And Download.
|