Trailer Hitch Kit
Part No. 5049751
Installation
Instructions
Fits Simplicity:
1694454
Fits Snapper:
5091000
1694455
5091001
1694460
This kit will install a trailer hitch on the rear
bumper.
Kit Contents:
Part No. Qty. Description
2849754
2849791
5049753
7091497
7091297
7090122
1
1
1
2
2
4
Trailer Hitch Plate
Support Plate
Warning Decal
3/8-16 x 1-1/2”Bolt
3/8-16 Hex Nylon Lock Nut
3/8” SAE Washer
Flush
A
Figure 1. Clamp Hitch Plate In Place
A. Hitch Plate
WARNING
Before beginning any service work turn off the
PTO, set the parking brake, turn off the ignition,
and disconnect the spark plug wire(s).
E
B
Tools Required:
(1) Drill & 7/16” drill bit
(1) 3/8” drive ratchet & 9/16” socket
(1) 9/16” combination wrench
(1) Prick punch & hammer
(1) Marker or pencil
D
C
B
(1) Vise-Grip clamp or C-clamp
INSTALLATION
A
1. Locate the holes on the bottom edge of the bumper.
If the bumper does not have pre-existing holes, con-
tinue with Step 2. If the bumper has holes, skip to
Step 4.
Figure 2. Install Hitch Plate
A. 3/8-16 x 1-1/2” Bolts
B. 3/8” SAE Washers
C. Hitch Plate
D. Support Plate
E. 3/8-16 Nylon Lock Nuts
2. Place the hitch plate (A, Figure 1) on the bottom
edge of the bumper. Center the plate side-to-side,
and flush with the inside edge. Clamp in place.
3. Using the holes in the hitch plate as a template,
mark the bumper with either a prick punch or mark-
er/pencil. Remove the mounting plate and drill 7/16”
holes through the bumper.
4. Install the tow hitch plate and support plate (C & D
Figure 2) on the bumper and install the 3/8-16 x 1-
1/2” bolts, washers and flange nuts (A,B & E).
Tighten hardware securely.
5. Clean the outside surface of the bumper, between
the hitch plate and rear shield with a mild cleaning
solution to remove any dirt or grease and dry. Apply
the warning decal as shown in Figure 3.
Figure 3. Install Warning Decal
49752
Rev. 4/2004
© Copyright 2004 Ferris Industries. All Rights Reserved.
TP 200-7153-00-SK-SN
Download from Www.Somanuals.com. All Manuals Search And Download.
|