Fisher Price Baby Accessories C1454 User Manual

C1454  
Instructions  
Please keep this instruction sheet for future reference, as it contains important information.  
Requires three “C” batteries (included).  
Adult assembly is required.  
Tool required for assembly: Phillips screwdriver (not included).  
c
Kick & Whirl Carnival  
Download from Www.Somanuals.com. All Manuals Search And Download.  
1
Battery Replacement  
Battery Safety Information  
Batteries may leak fluids that can cause a chemical burn injury or ruin  
your toy. To avoid battery leakage:  
• Do not mix old and new batteries or batteries of different types:  
alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).  
1.5V x 3  
• Insert batteries as indicated inside the battery compartment.  
"C" (LR14)  
• Remove batteries during long periods of non-use. Always remove  
exhausted batteries from the toy. Dispose of batteries safely. Do not  
dispose of batteries in a fire. The batteries may explode or leak.  
• Never short-circuit the battery terminals.  
SHOWN ACTUAL SIZE  
• Use only batteries of the same or equivalent type, as recommended.  
• Do not charge non-rechargeable batteries.  
• Remove rechargeable batteries from the toy before charging.  
• If removable, rechargeable batteries are used, they are only to be  
charged under adult supervision.  
Battery Compartment Door  
For best performance, we recommend replacing the batteries that  
came with this toy with three, new alkaline “C” (LR14) batteries.  
• Locate the battery compartment on the back of the Ferris  
wheel assembly.  
• Loosen the screws in the battery compartment door with a Phillips  
screwdriver. Remove the battery compartment door. Remove the  
exhausted batteries and throw them away.  
• Insert three “C” (LR14) alkaline batteries.  
Hint: We recommend using alkaline batteries for longer life.  
• Replace the battery compartment door and tighten the screws with a  
Phillips screwdriver. Do not over-tighten.  
• When lights, sounds, or motions from this toy become faint or stop, it’s  
time for an adult to change the batteries.  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
Assembly  
Track  
Track  
Base  
Base Support  
1
• Insert the other track into the opposite side of the base.  
4
• Insert a track into one side of the base as shown.  
• Insert and “snap” the base support into the base.  
1
#8 x / " Screw  
1
#8 x / " Screw  
2
2
Ramp Cover  
2
Turn the assembly over so the bottom of the base is facing you.  
Bottom View  
Ramp  
5
1
2
• Insert four #8 x / " screws through the base and into the tracks.  
Tighten the screws.  
• Fit a ramp cover onto a ramp as shown.  
1
2
• Insert two #8 x / " screws into the top of the cover and tighten them.  
Turn the base upright.  
Base  
Base Door  
1
#8 x / " Screw  
2
6
ramp. Tighten the screws with a screwdriver.  
3
1
• Position the base door so that the decorated side is facing you.  
• Insert the peg on one end of the base door into the hole in the base.  
• Bend the door slightly and insert the other peg into the hole in the base.  
2
Turn the ramp over and insert four #8 x / " screws into the back of the  
• Repeat this procedure to attach the other ramp cover.  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
Assembly  
Ramp  
#8 x 2" Shoulder Screw  
Ferris Wheel  
Ferris Wheel Assembly  
1
#8 x / " Screw  
2
7
• Position the Ferris wheel assembly so that the back is facing you.  
• Fit one of the ramps on the back of the Ferris wheel assembly  
as shown.  
1
2
• Insert four #8 x / " screws through the ramp and into the Ferris wheel  
assembly. Tighten the screws.  
• Repeat this procedure to attach the other ramp to the Ferris wheel.  
Hub  
Ferris Wheel  
9
in place.  
Ramp  
• Rotate the Ferris wheel down toward the base. The arch should “click”  
• Insert a #8 x 2" shoulder screw into the hub on the end of one ramp.  
Tighten the screw.  
• Insert the other #8 x 2" shoulder screw into the opposite hub. Tighten  
the screw.  
Hub  
Base Door  
Track  
8
• Position the base assembly so that the base door is facing you.  
• Position Ferris wheel assembly so that the decorated side is facing you.  
• Fit the hub on the end of one ramp onto the track as shown.  
• Bend the track slightly and fit the other hub to the opposite side of  
the track.  
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
Kick-Activated Gym  
To convert to a Kick-Activated Gym, pull up on the center clamp under the Ferris wheel to “snap” the arch into position.  
• Snap the balls onto the pegs on the Ferris wheel.  
• Snap the spinning toys into the clamps under the Ferris wheel.  
• Slide the mode switch to the I position.  
• Slide the volume switch on the back of the Ferris wheel to either low volume  
or high volume  
.
• Baby can kick the base or bat at the toys for about five minutes of fun music, sound effects and colorful spinning balls.  
• Slide the mode switch to  
O
to turn power off.  
Pegs  
Mode Switch  
Volume Switch  
Spinning Toy  
Clamps  
6
Download from Www.Somanuals.com. All Manuals Search And Download.  
Sit-Up Fun  
To convert to Sit-Up Fun, press the button near each ramp cover at the same time, push the Ferris wheel down until it “clicks” into position.  
• “Pop” the colorful balls off the pegs on the Ferris wheel.  
• Fit the spinning toys onto the pegs in the ramp covers or on the track.  
• Open the base door.  
• Slide the mode switch to the II position.  
• Slide the volume switch on the back of the Ferris wheel to either low volume  
or high volume  
.
• Drop the colorful balls through the openings in the base or place balls in the Ferris wheel and watch them roll down the ramps. Short music plays as  
lights flash encouraging continued play.  
• Slide the mode switch to  
O
to turn the power off.  
Pegs  
Mode Switch  
Volume Switch  
Button  
Button  
Base Door  
7
Download from Www.Somanuals.com. All Manuals Search And Download.  
Consumer Information  
Questions? We’d like to hear from you!  
Care  
• Wipe this toy with a clean damp cloth dampened with a mild soap and  
water solution.  
Call Fisher-Price® Consumer Relations, toll-free at 1-800-432-5437,  
8 AM - 6 PM EST Monday through Friday. Hearing-impaired  
consumers using TTY/TDD equipment, please call 1-800-382-7470.  
• Do not immerse this toy.  
Or, write to:  
Fisher-Price® Consumer Relations  
636 Girard Avenue  
East Aurora, New York 14052, U.S.A.  
FCC Statement (United States Only)  
Note: This equipment has been tested and found to comply with the  
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.  
These limits are designed to provide reasonable protection against harmful  
interference in a residential installation. This equipment generates, uses  
and can radiate radio frequency energy and, if not installed and used in  
accordance with the instructions, may cause harmful interference to radio  
communications. However, there is no guarantee that interference will not  
occur in a particular installation. If this equipment does cause harmful  
interference to radio or television reception, which can be determined by  
turning the equipment off and on, the user is encouraged to try to correct  
the interference by one or more of the following measures:  
For countries outside the United States:  
CANADA  
Questions? 1-800-567-7724, Mattel Canada Inc., 6155 Freemont Blvd.,  
Mississauga, Ontario L5R 3W2.  
GREAT BRITAIN  
Mattel UK Ltd, Vanwall Business Park, Maidenhead SL6 4UB. Helpline: 01628 500302.  
AUSTRALIA  
Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond,  
Victoria 3121 Australia. Consumer Advisory Service 1300 135 312.  
• Reorient or relocate the receiving antenna.  
NEW ZEALAND  
16-18 William Pickering Drive, Albany 1331, Auckland.  
• Increase the separation between the equipment and receiver.  
• Consult the dealer or an experienced radio/TV technician for help.  
ASIA  
Mattel East Asia Ltd, Room 1106, South Tower, World Finance Centre, Harbour City,  
Tsimshatsui, HK, China.  
Note: Changes or modifications not expressly approved by the  
manufacturer responsible for compliance could void the user’s  
authority to operate the equipment.  
Fisher-Price, Inc., a subsidiary of Mattel, Inc. East Aurora, New York 14052, U.S.A.  
©2004 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.  
PRINTED IN CHINA  
C1454a-0920  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Clarion CD Player DXZ665MP User Manual
Craftsman Lawn Sweeper 48624229 User Manual
Craftsman Trimmer 31679249 User Manual
Cres Cor Convection Oven CO151F1818B User Manual
Danby Microwave Oven DMW1157PL User Manual
Electro Voice Microphone HM1x User Manual
Electro Voice Portable Speaker SH 1502ER User Manual
Extron electronic TV Cables 26 613 XX User Manual
Frigidaire Ventilation Hood PL36WC41EC User Manual
Fusion Car Stereo System CA ML600 User Manual