Amana cannot be responsible
for improper installation.
Attention Installer
Shim refrigerator
wheels as needed
ꢀ
• Make sure cutout floor is level. If the floor is not
level it is necessary to shim the rear wheels onto
a piece of plywood or other shim material so
refrigerator is level.
!
WARNING
To avoid electrical shock which can cause severe
personal injury or death, disconnect power outlet
from main power supply before installing or
servicing refrigerator.
!
CAUTION
Some installations may require door removal to
get the refrigerator into the home.
1. Remove toe grille.
2. Remove top hinge cover and top hinge.
To avoid electrical shock which
can cause severe personal
injury or death, green ground wire
B
.
must remain attached to hinge
Dispensing and Electronic Models
• Disconnect wire connectors.
Loosen the water tube clamp (A). Loosen the
water tube union nut (B). Pull the water tube
away from the union nut and through the tube
clamp.
C
• Unplug electrical connector from voltage box (C).
A
3. Remove doors.
•
•
•
Remove top hinges.
Remove doors from bottom hinge.
Remove bottom hinge.
4. Attach
Top right
refrigerator to
appliance cart.
Top left
Bottom
right
!
Bottom
left
CAUTION
To avoid floor and wall damage
protect walls and soft vinyl or other
flooring with masonite or other protective
material when moving the refrigerator.
"P" clamp
1. Reinstall doors by performing section 2 in
reverse order.
Brass nut
2. Connect ice maker water supply line. (Refer to
Owner’s Manual)
Copper
tubing
Loosen hinge screws
Brass sleeve
3. Plug power cord into electrical receptacle.
4. Move refrigerator into final location.
5. Once refrigerator is located and stable, level
refrigerator by adjusting front, and rear (some
models) cabinet leveling adjustment screws.
6. Reconnect power from power source to electrical
receptacle.
2 turns counterclockwise
Water valve
inlet connection
cabinet leveling
adjustment screw
7. Align doors.
• To align tops of doors loosen the 2 bottom
ALIGN
right side hinge screws. Turn cam to raise or
lower refrigerator door (Some models). (Refer
to label inside refrigerator compartment on
bottom mullion.)
• Tighten the 2 hinge screws.
8. Replace toe grille.
Door alignment
adjustment cam
(some models)
1. Remove all interior packaging material.
2. Clean interior and exterior of refrigerator.
3. Instruct consumer on controls and features.
4. Verify power to refrigerator is connected.
Part No. 12123312
Printed in U.S.A.
Download from Www.Somanuals.com. All Manuals Search And Download.
|