Norris Parts Repair Manual
1
Dell 2000FP Logic Board
Installation Instructions
Copyright©2006 – All Rights Reserved - Distribution or Duplication of this document is prohibited.
Norris Parts Repair Manual
3
Disassembly
Step 1:
Remove the four (4) screws from the
top of the base.
Step 2:
Remove the base.
Step 3:
Remove the four (4) screws from the
back cover.
Copyright©2006 – All Rights Reserved - Distribution or Duplication of this document is prohibited.
Norris Parts Repair Manual
4
Step 4:
Stick a flat screw driver between the
back cover and the front bezel on
the bottom of the LCD.
Step 5:
Remove the back cover from the
bottom of the LCD.
Step 6:
Remove the back cover from the
bottom of the LCD.
Copyright©2006 – All Rights Reserved - Distribution or Duplication of this document is prohibited.
Norris Parts Repair Manual
5
Step 7:
Rotate the LCD to the side to
continue removing the back cover.
Step 8:
Rotate the LCD to the other side to
continue removing the back cover.
Copyright©2006 – All Rights Reserved - Distribution or Duplication of this document is prohibited.
Norris Parts Repair Manual
6
Step 9:
Remove the back cover.
Step 10:
Remove the two (2) screws from
the inverter board’s metal cover.
Step 11:
Remove the inverter board’s metal
cover.
Copyright©2006 – All Rights Reserved - Distribution or Duplication of this document is prohibited.
Norris Parts Repair Manual
7
Step 12:
Remove the fifteen (15) screws
from the logic board’s metal cover.
Step 13:
Remove the logic board’s metal
cover.
Copyright©2006 – All Rights Reserved - Distribution or Duplication of this document is prohibited.
Norris Parts Repair Manual
8
Step 14:
Unplug connector from the logic
board.
Step 15:
Unplug the two (2) connectors
from the logic board.
Step 16:
Unplug connector from the logic
board.
Copyright©2006 – All Rights Reserved - Distribution or Duplication of this document is prohibited.
Norris Parts Repair Manual
9
Step 17:
Unplug connector from the logic
board.
Step 18:
Remove the seven (7) screws from
the logic board.
Copyright©2006 – All Rights Reserved - Distribution or Duplication of this document is prohibited.
Norris Parts Repair Manual
10
Step 19:
Remove the logic board.
Step 20 – Reassembly
Inspect new part ensuring that any packing materials or tape are removed.
Follow the directions in reverse to complete the installation of the replacement part. Make
sure that all connectors are plugged in. Make sure that you replace all screws into their
assemblies.
Copyright©2006 – All Rights Reserved - Distribution or Duplication of this document is prohibited.
|