X10 Wireless Technology Indoor Furnishings SW C LAI358 User Manual

Single & 3-Way Decorator Wall Dimmer Set Up and Operating Instructions WS12A/WS14A  
Traveller  
wires  
Cap off with  
wire nut  
WS12A  
Master  
WS14A  
Companion  
WS12A  
A
B
The WS12A Wall Dimmer Module is designed to control incandescent loads with a rating of between 40W and 500W. Lamps rated  
below 40W may flicker or operate erratically. The switch can replace a single switch that controls a ceiling light or outside light. It  
can also be used where two switches control the same light (3-way). In this case a Companion Switch (WS14A) is required and is  
sold separately. A push-button is provided on each switch for local on/off control and local dimming. (See WS14A instructions for 4-  
way applications).  
WARNING:Wall Dimmer Modules must not be used to control appliances or fluorescent lamps.  
Installing the Wall Dimmer Module (single switch applications, diagram A)  
• Disconnect the power at the circuit breaker.  
• Remove the wall plate and unscrew the existing switch from its box.  
• Remove the two wires from the existing switch and connect them to the two wires on the WS12A, using the wire nuts provided.  
• Cap off the unused red wire with a wire nut (supplied). Make sure no bare whiskers of wire are protruding, use insolating tape to  
cover wire nuts if necessary. Screw the switch into the wall box and replace the wall plate.  
Installing the Wall Dimmer Module (3-way applications, diagram B)  
• Disconnect the power at the circuit breaker.  
• Remove wall plates and unscrew the existing switches from their boxes. Identify the common wire at each existing switch (usually  
connected to a different color terminal).  
• Replace one of the existing wall switches with the WS12A Wall Dimmer (Master): connect the common wire to the blue wire on  
the WS12A using a wire nut. Connect the two remaining "traveller wires" to the red and black wires on the WS12A, using wire  
nuts. If one of the travellers is red connect it to the red wire on the WS12A.  
• Replace the other existing wall switch with the WS14A Companion Switch (sold separately): connect the common wire to one of  
the WS14A's terminals labelled LIVE. Connect the traveller which you connected to the red wire on the WS12A to the terminal  
labelled SWITCH on the WS14A. Connect the remaining traveller wire to the second terminal labelled LIVE on the WS14A. Screw  
both switches into their wall boxes and replace the wall plates.  
Setting up and operating the Wall Dimmer Module  
• Pop the rocker paddle off the WS12A (using a small screwdriver). Set the House Code dial to the same letter (A thru P) that you  
set on your X-10 controller(s).  
• Set the Unit Code dial to an unused code (1 - 16) which can be controlled from any X-10 controller. Replace the paddle.  
• Set the power on-off slide switch (under the rocker paddle) to the ON (right) position. Turn this switch OFF (left) when changing a  
light bulb.  
• Press the paddle quickly to turn the module on and off. Press and hold to dim or brighten. Note: if you press the paddle and  
nothing happens, you might have pressed it for too long and started to dim the light and not noticed that it dimmed.  
You can turn the module on and off and dim and brighten it remotely from any X-10 Controller.  
LIMITED 1-YEAR WARRANTY X-10 (USA) Inc. warrants X-10 products to be free from defective material and workmanship for a  
period of one (1) year from the original date of purchase at retail. X-10 (USA) Inc. agrees to repair or replace, at it’s sole discretion, a  
defective X-10 product if returned to X-10 (USA) Inc. within the warranty period and with proof of purchase. If service is required under  
this warranty:  
1. Return the defective unit postage prepaid to X-10 (USA) Inc. at the address below.  
2. Enclose a check for $4.00 to cover postage and handling.  
3. Enclose a dated proof of purchase.  
4. X-10 is not responsible for shipping damage. Units returned should be packed properly to avoid damage.  
WS12A -9/98  
X-10 (USA) Inc., 91 Ruckman Rd. Closter, NJ 07624. www.x10.com  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Weil McLain Boiler CGM Series 7 User Manual
Westinghouse Flat Panel Television UW48T7HW User Manual
Whirlpool Air Conditioner AC1 352 User Manual
Whirlpool Air Conditioner ACP102PR0 User Manual
Winegard Stereo Amplifier AP8700 User Manual
Wybron Work Light Optic User Manual
X Micro Tech Headphones P3 Player FM RADIO EARPHONE User Manual
Xpelair Fan LVCF20 User Manual
Yamaha DVD Player DV S6165 User Manual
Yamaha Music Mixer DSP1D EX User Manual