ET-3204 Translucent Desktop Neon Fashion Phone
OWNER’S MANUAL — Please read before using this equipment.
FEATURES
„ Flash
FCC STATEMENT
„ Adjustable Ringer
Your telephone complies with Part 68 of the FCC Rules. You must,
upon request, provide the FCC registration number and the REN to
your telephone company. Both numbers are on the bottom of your
phone.
„ Redial
„ Handset Volume Control
„ Hearing Aid Compatible
„ Reset
Note: You must not connect your telephone to:
• coin-operated systems
„ Neon Light
WARNING: To reduce the risk of fire or shock hazard, do
not expose this product to rain or moisture.
• party-line systems
• most electronic key phone systems
CAUTION
RISK OF ELECTRIC SHOCK. DO NOT
OPEN.
!
CONNECTING THE PHONE
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER OR BACK. NO
USER-SERVICEABLE PARTS INSIDE. REFER SERVIC-
ING TO QUALIFIED PERSONNEL.
Cautions:
You must use a Class 2 power source that supplies 9V
DC and delivers at least 200 mA. Its center tip must be
set to positive and its plug must fit the phone's DC 9V
!
jack. The supplied adapter meets these specifications. Using an
adapter that does not meet these specifications could damage the
phone or the adapter.
This symbol is intended to alert you to the
presence of uninsulated dangerous voltage
within the product’s enclosure that might be
of sufficient magnitude to constitute a risk
of electric shock. Do not open the product’s
case.
• Always connect the AC adapter to the phone before you connect
it to AC power. When you finish, disconnect the adapter from AC
power before you disconnect it from the phone.
Notes:
This symbol is intended to inform you that
important operating and maintenance
• The adapter powers the light.
• The USOC number of the jack to be installed is RJ11C.
instructions are included in the literature
accompanying this product.
!
READ THIS FIRST
We have designed your telephone to conform to federal regulations
and you can connect it to most telephone lines. However, each device
you connect to the phone line draws power from it. This power draw is
the device’s Ringer Equivalence Number, or REN. The REN is on the
bottom of your phone.
If you are using more than one phone or other device on the line, add
up all the RENs. If the total is more than five (or three in rural areas)
your phones might not ring. If ringer operation is impaired, remove one
of the devices from the line.
Line
Cord
DC 9V
Jack
If your phone causes problems on the phone line, the telephone com-
pany can disconnect your service. The phone company tries to notify
you in advance. If advance notice is not practical, the telephone com-
pany notifies you as soon as possible and advises you of your right to
file a complaint with the FCC.
Plug one end of the supplied line cord into the jack on the back of
base, and plug the cord's other end into a modular phone line jack. In-
sert the supplied AC adapter's barrel plug into the DC 9V jack on the
back of the phone. Then plug the other end of the adapter into a stan-
dard AC outlet.
The phone company can also make changes to its lines, equipment,
operations, or procedures that could affect the phone’s operation. The
phone company notifies you in advance, so you can take the neces-
sary steps to prevent interruption of your phone service.
© 2000 Tandy Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks used by Tandy Corporation.
Download from Www.Somanuals.com. All Manuals Search And Download.
|