HYBRID AMPLIFIER
Audio Digital Amplifier
Main Channel Power Output
1
PMPO,8 Ohms, 1KHz test
1000WX2
<1%
3000WX2
<1%
2
3
4
THD(1KHz)
Normal Load Impedance
8 Ohm
8 Ohm
Input Sensitivity Impedance
CD/DVD AUX TAPE TUNER
400mV/33k Ohm
6mV/600 Ohm
400mV/33k Ohm
6mV/600 Ohm
Microphone
5
6
Signal to Noise Ratio
Pure Amplifier
78dB
76dB
78dB
76dB
7
8
Frequency Range
Frequency Response(20Hz-20KHz)
±2dB
±2dB
9
±10dB
±10dB
Tone Characteristic(100Hz-10KHz)
Power Requirements
10
AC~110V/60Hz AC~220V50Hz
483(W)X300(D)X140(H)mm
11
12
Dimension
Weight
6kg
6.5kg
※ Specifications subject to change without prior notice
4
PDF created with pdfFactory trial version www.pdffactory.com
1、
2、
3、
4、
5、
6、
7、
8、
SPEAKER
Speaker
（
A/B
）
Selector
SPEAKER
1
2
ENGINEERED IN JAPAN
DESIGNEDIN THE USA
Speaker
DVD/CD
（A+B） Selector
WARNI NG
3
4
DVD/CD Selector
AUX
-
5
6
AUX Selector
TUNER
TUNER Selector
TAPE
7
8
TAPE Selector
VOL+
Master Volume Up
VOL-
Master Volume Down
Remote Controller Operation
1. Remote controller should be operated within 6
meter and the scope of 30 in front of receiver.
2. Make sure that there is no big obstacle between
remote controller and machine.
3. Remote sensor should be far away
from the light,high amounts of light can affect itsperformance.
5
PDF created with pdfFactory trial version www.pdffactory.com
2 MIC
INPUTS
ENGINEERED IN JAPAN
DESIGNED IN THEUSA
WARNI NG
1. Make sure that all connections are properly connected and the main
volume is set to minimum level before turning on the unit.
2. When more than one pair of speakers are used, (specially the main
speaker output) make sure that the speakers used are of the same
wattage and impedance, otherwise the unit may be damaged under
high power or long term operation.
-
TAPE
3. To avoid humming sounds and unwanted noise, make sure that all the
wires are properly inserted.
TUNER
4. For speaker cords, strip off the vinyl coating and twist the wire tip.
Push down the pink jack or loosen the screw terminal, before inserting
the wire tip, then fasten it and tighten the screw. Be careful not to let
the wires stick out of the terminal otherwise this may cause a short
circuit when wires of different terminal contact each other.
5. After the unit is turned on, adjust the main volume to the desired level
same is true with the bass and treble volume, etc.
DVD/CD
AUX
CD Recorder
Main (A)Speakers
Main (B)Speakers
8
7
PDF created with pdfFactory trial version www.pdffactory.com
|