Kambrook 4 Kingston Town Close Oakleigh,Victoria 3166,Australia
Customer Service Line (free call) 1800 800 634 Customer Service Fax 1800 621 337
Kambrook New Zealand, Private Bag 94411, Greenmount, Auckland, New Zealand
Customer Service Line/Spare Parts 09 271 3980 Customer Service Fax 0800 288 513
Jaguar Power Twister
Vacuum Cleaner
Due to continual improvement in design or otherwise, the product you purchase may differ slightly from the one illustrated in this book. Issue 1/03
Download from Www.Somanuals.com. All Manuals Search And Download.
KBV30
Issue 1/03
For full suction power ensure that the
fingertip suction control cover (on the
top of the hose) is closed.The suction
power can be reduced by opening the
suction control cover.
can be stored on the telescopic wand tool IMPORTANT: DO NOT USETHE
UsingYour Kambrook Jaguar
‘PowerTwister’ Bagless
Vacuum Cleaner
Remove all packaging from the unit, hose
and other accessories; ensure that you
have removed all of the accessories before
discarding the packaging.
storage stand for easy access and storage.
UNIT WITHOUTTHE DUST
CANISTER IN PLACE
Turn the vacuum cleaner OFF when
changing any attachments.
Replacing / Cleaning filters
HEPA and Micro Dust Filter
There are 2 dust filters located inside the
dust canister.The outer filter is the Micro
Dust filter and the inner filter is the HEPA
filter.
ParkTool Feature
When vacuuming is complete, turn the
vacuum cleaner ‘OFF’ by pushing down on
the ‘ON/OFF’ foot pedal.Turn the power
off at the outlet and then remove the
power cord from the power outlet (when
removing plug from the power outlet
grasp the plug not the cord).
The park tool feature can be used to park
the wand in the upright (storage) position
Ensure that the dust canister and filters
are correctly fitted.
The park tool attachment hook, for upright
storage is located on the lower wand.
To remove these filters for cleaning, follow
the instructions listed under ‘Emptying the
dust canister’ on page 5.
Locate the crush proof hose and push the
connection point into the hose inlet
connection on the top of the unit, until a
“click” sound is heard.
With the vacuum switched off and
unplugged from the power point, insert
the park tool hook into the park tool
receptacle on the vacuum body
To retract the cord push down on the
‘cord rewind’ foot pedal.
Once the dust canister lid has been
removed, hold the top of the lid with one
hand and grasp the bottom of the filter
with the other hand to separate the filters
from the dust canister
To extend the telescopic wand, push the
extension lever in the direction of the
arrow (printed on the lever) and pull out
the narrower tube to the desired height.
Note:The floor tool should be attached and in
contact with the floor to give stability, if correctly
assembled.
IMPORTANT: HOLDTHE PLUG
END WHEN RETRACTINGTHE
CORDTO PREVENT IT FROM
STRIKINGYOU ORTHEVACUUM.
Emptying the Dust Canister
The dust canister should be emptied
when the dust inside the canister reaches
the max marking (indicated on the side of
the canister).
lid.You may need to
rotate the bottom of
the filter slightly
clockwise to release.
Connect the wide end of the telescopic
tube on to the hose end, and push
together firmly.
ALWAYS ENSURETHATTHE
DUST CANISTER IS CORRECTLY
FITTED. NEVER OPERATE
WITHOUTTHE DUST CANISTER
IN PLACE.
Fit the floor head to the narrow end of
the wand and push together firmly
The HEPA filter and Micro dust filter can
be washed in lukewarm water.Allow to
dry completely before placing the filters
back into the dust canister.
Always switch the appliance off, then
switch off at the power outlet and unplug
the appliance prior to emptying the dust
canister or changing filters.
Fully extend the power cord by pulling
the power plug (situated at the rear of the
unit) out from the unit, until the yellow
tape on the cord is shown.
Crevice and brush tool accessories
The crevice tool is ideal for vacuuming
hard to reach places such as the edges
along skirting boards, crevices, corners
and in between cushions.
To reposition the HEPA filter and Micro-
filter follow these steps:
To remove the dust
canister, press the ‘dust
canister compartment
release button’ located
on the side of the unit.
The canister will then
slide out.
ENSURETHATYOU DO NOT
OVER EXTENDTHE POWER
CORD – DO NOT EXTEND PAST
THE RED WARNINGTAPE ON
THE CORD
1. Hold the base of the HEPA filter
The upholstery tool can be used to
vacuum delicate surfaces and areas such
as shelves, venetian blinds , furniture and
lamp shades.
2. Slide the Micro-dust filter over the
HEPA filter
3. Still holding the base of the filter in one
hand, take the dust canister lid in the
other hand and push the filter onto the lid
so that the round opening in the filter fits
over the round opening in the dust
canister lid.
Plug into a 230/240v power point and
switch the power on.
When using the crevice and upholstery
tools, slide the Fingertip Suction Control
cover (located on the wand handle) to the
open position to reduce suction.
NOTE:The canister compartment lid may not close
if the canister is not correctly fitted.
To commence vacuuming push down on
the on/off foot pedal, at the top, rear of
the unit.
Both the Crevice and Uupholstery tools
4
5
Download from Www.Somanuals.com. All Manuals Search And Download.
Air exhaust filter
The air exhaust filter is
located at the front,
right hand side of the
unit. Rotate the plastic
filter holder anti-
Notes
clockwise to remove.
Care and Maintenance
Always switch appliance off, then switch
off at the power outlet and unplug the
vacuum cleaner prior cleaning or replacing
either filter.
To clean the outside of the unit, wipe the
exterior with a soft, damp cloth. Never
use an abrasive cleaner.
To clean the dust canister, remove the
dust canister lid and rinse the canister
with lukewarm water. Ensure the canister
is completely dry before replacing the
dust canister lid for use.
From time to time hair, cotton and other
items may get caught in the brushes of the
Turbo Head and prevent it from spinning
around.To remove such items, take a pair
of scissors and cut the across the cotton,
hair etc. to loosen, then gently pull to
remove.
NOTE: Do not continue to pull if the item/s does
not easily come out as this may permanently
damage the Floor Head.
6
7
Download from Www.Somanuals.com. All Manuals Search And Download.
Notes
Notes
8
9
Download from Www.Somanuals.com. All Manuals Search And Download.
KAMBROOK
12 MONTH
Notes
REPLACEMENT WARRANTY
If the product includes one or a number of
accessories only the defective accessory
or product will be replaced.
KAMBROOK warrants the purchaser
against defects in workmanship and
material, for a period of 12 months from
the date of purchase (3 months
commercial use).
In the event of KAMBROOK choosing to
replace the appliance, the guarantee will
expire at the original date, ie. 12 months
from the original purchase date.
Guarantee and purchase receipt for this
product are to be retained as proof of
purchase and must be presented if making
a claim under the terms of the
In Australia, this KAMBROOK Guarantee
is additional to the conditions and
guarantees which are mandatory as
implied by the Trade Practices Act 1974
and State Territory legislation.
KAMBROOK guarantee.
KAMBROOK reserves the right to
replace or repair the appliance within
the warranty period.
For service, spare parts or product
information in Australia, please call
KAMBROOK on the customer Service
Line (free call) 1800 800 634.
Warranty does not apply to any defect,
deterioration, loss or injury or damage
occasioned by, or as a result of the misuse
or abuse, negligent handling or if the product
has not been used in accordance with the
instructions.The guarantee excludes
breakages and consumable items such as
kneading blades.
For service, spare parts or product
information in New Zealand,
please call KAMBROOK New Zealand,
Greenmount, Auckland Phone 09 271 3980
Fax 0800 288 513. For spare parts phone
09 271 3980.
This warranty is void if there is evidence
of the product being tampered with by
unauthorised persons.
If claiming under this guarantee the product
must be returned to freight prepaid.
YOUR PURCHASE RECORD (Please complete)
Attach purchase receipt here.
DATE OF PURCHASE___________________________
MODEL NUMBER _____________________________
SERIAL NUMBER (If applicable) ___________________
Please don’t return purchase record
unless you are making a claim
PURCHASED FROM ___________________________
10
11
Download from Www.Somanuals.com. All Manuals Search And Download.
|